The interface of switch S1 is in access mode

A switch port can work in two modes: access and trunk. In access mode, it works with a single VLAN. If you connect an end device to a switch port, you do not need. Cisco switches can be configured with a special IP address known as the switch virtual interface (SVI). If the VLAN 1 SVI is assigned an IP address, by default, all ports on VLAN 1 have. This video will demonstrate the Configure procedure of Access Mode Interfaces for S-Series Switch. Please see the installation guide for the switch. Cisco NX-OS supports only IEEE 802. Step 2: Create. My question is about the output of S1#sh int gig1/1 switch (same output on the other interfaces and switches) If I would add switchport access vlan 40 to all gig interfaces. [pdf]