A switch port can work in two modes: access and trunk. In access mode, it works with a single VLAN. If you connect an end device to a switch port, you do not need. Cisco switches can be configured with a special IP address known as the switch virtual interface (SVI). If the VLAN 1 SVI is assigned an IP address, by default, all ports on VLAN 1 have. This video will demonstrate the Configure procedure of Access Mode Interfaces for S-Series Switch. Please see the installation guide for the switch. Cisco NX-OS supports only IEEE 802. Step 2: Create. My question is about the output of S1#sh int gig1/1 switch (same output on the other interfaces and switches) If I would add switchport access vlan 40 to all gig interfaces.
[pdf] A practical, engineering-focused guide to planning and installing underground fiber optic cables with the right cable structure, trench design and protection level for long-life, low-risk networks. Match trench method with the correct underground fiber structure (GYTS, GYTA53, GYTY53, micro-duct). Underground cables are pulled in conduit that is buried underground, usually 1-1. 2 meters (3-4 feet) deep to reduce the likelihood of accidentally being dug up.
[pdf] 
