Fiber optic cables cannot usually connect directly to a standard router; an Optical Network Terminal (ONT) is required to convert the optical signal into an electrical signal for the router.

Required Equipment

To set up a fiber connection, you will need:

• Optical Network Terminal (ONT): Converts the fiber's light signal into an electrical signal compatible with your router .
• Fiber optic cable: Typically provided by your ISP, with SC/APC or SC/UPC connectors .
• Router: Ensure it has a WAN or SFP port compatible with fiber input .
• Ethernet cable (Cat5e or higher): Connects the ONT to the router .

Step-by-Step Connection

1. Install the ONT
   • Locate the fiber wall outlet where the ISP's fiber line enters your home.
   • Connect the fiber optic cable from the wall outlet to the ONT's optical port. Handle the fiber carefully to avoid dirt or damage .
   • Power on the ONT and wait for the status lights to stabilize, which may take a few minutes .
2. Connect the ONT to the Router
   • Use an Ethernet cable to connect the ONT's LAN or Ethernet port to the router's WAN port .
   • Power on the router and wait for the indicator lights to confirm a successful connection.
3. Verify the Connection
   • Check your devices to ensure internet access is working.
   • If required, log into the router's settings to enter ISP credentials or configure VLAN/PPPoE settings .

Important Precautions

• Always turn off the router before connecting cables to prevent damage .
• Avoid bending the fiber cable sharply, as it can break the delicate glass strands .
• Keep fiber connectors clean and free from dust; use protective caps when not connected .
• Place the ONT and router in a dry, ventilated area near a power source, ideally with surge protection . By following these steps, your fiber optic internet will be properly converted and routed through your home network, ensuring high-speed and reliable connectivity.